Skip to main content
Frata Ingenieros

Angle Connector

Join two parallel pipes, conduits or cable trays with an offset at the angle you choose, with both elbows created for you.

General Description

Choose an angle in the window, press Execute and click the two elements near the ends you want to join. Three arrows appear next to them: hover an arrow to preview the route and click it to create the connection. Both elements are extended or trimmed as needed, the angled piece is created with the same type and size, and an elbow is added at each side. Nothing is added to your model while the arrows are shown.

Key Features

  • Preset angles of 90°, 60°, 45°, 30°, 22.5° and 11.25°, or any value you type from 1° to 90°.
  • Works for offsets in height, in plan or both at once, and for vertical risers.
  • Three placement arrows: bend at the first element, centered, or at the second element.
  • Live preview of the route before anything is created.
  • Elements are trimmed automatically when the ends are too close for the chosen angle.

Requirements

  • Two parallel elements of the same kind (two pipes, two conduits or two cable trays), each with a free end, and those ends facing each other.
  • An open 3D, plan, section or elevation view.

Usage Procedure

  1. Open Angle Connector from the MEP panel on the Frata ribbon tab.
  2. Pick a preset in Angle or type your own value, then press Execute.
  3. Click the first element near the end to connect.
  4. Click the second element near the end to connect.
  5. Hover the arrows to preview each option and click the one you want.
  6. Repeat with other pairs, or press Esc to finish.

Notes

  • An arrow is hidden when that option would leave one of the elements too short.
  • The elbows come from the routing preferences of the element type. If the type has no fitting for the chosen angle, the pair is listed in a results window with the reason.
  • Each connection is a single undo step.
BIMtools privacy policy